Espresso

Espresso forces pressurised water through a finely ground, tightly packed bed of coffee. The result is thick, creamy and concentrated, and can be drunk as it is or used as the base for long blacks, cappuccinos, lattes and flat whites.

What you will need for one cup

  • A semi-automatic espresso machine with a portafilter
  • An espresso tamper
  • 18 g of fresh coffee, ground fine for espresso
  • 28–36 g of brew water at 91–96°C
  • An espresso glass or cup
  • A timer
  • A total brew time of 22–30 seconds

Method

  1. Remove the portafilter from the group head — twist right to left until it dislodges.
  2. Flush the group head for two to three seconds.
  3. Empty the portafilter and make sure there is no leftover residue or moisture.
  4. Measure the coffee on scales for an exact dose.
  5. Put the coffee in the portafilter and level it with a light shake or a dosing tool.
  6. Tamp firmly and level, forcing out air pockets and creating a consistent bed for the water.
  7. Clean the rim and spouts of the portafilter, and purge the group head.
  8. Lock the portafilter into the group head, twisting left to right, and put the cup in place.
  9. Start the water flow as soon as the portafilter is in.
  10. Watch the extraction time; adjust to taste.
  11. Stop the water flow when the shot is poured.
  12. Clean the machine.

Cafetière

The French press gives you more control over the brew and produces a richer, fuller-bodied cup than drip coffee.

What you will need for one cup

  • 15 g of coffee, coarse ground
  • 325 ml of water
  • A French press
  • A kettle
  • A timer and scales
  • A total brew time of 4:30

Method

  1. Prepare the ingredients and equipment.
  2. Boil the water and set it aside for a moment.
  3. Rinse the empty press with hot water to hold the temperature. This is optional.
  4. Add the coffee and a little water to wet the grounds; wait 30 seconds and stir gently with a chopstick. Cover to keep the heat in.
  5. Add the remaining water and lower the plunger until it touches the water — do not plunge yet.
  6. Steep for 3 minutes 30 seconds.
  7. Push the plunger down slowly to filter the grounds.
  8. Pour immediately. If you brewed a large batch, decant it: coffee left sitting on the grounds turns bitter.

V60

The V60 is a pour-over, also known as drip brewing. It lets the subtlest flavours through and is easy to learn.

What you will need for one cup

  • A V60 dripper and filter paper
  • A kettle
  • A burr grinder (recommended)
  • 15 g of coffee, medium-fine
  • 250–325 ml of water at 94°C
  • A total brew time of 3–4 minutes for a 12 oz mug

Method

  1. Heat the water to 94–97°C.
  2. Fold the filter into a cone, place it in the V60 and rinse it with hot water.
  3. Use freshly roasted whole beans, ground medium-fine.
  4. Pour the water slowly and steadily, avoiding the sides of the filter.
  5. Let the coffee drain through. Aim for a total brew time of 3–4 minutes.
  6. Drink it immediately, and clean the equipment after each brew.

Chemex

The Chemex uses a thicker, double-bonded filter that removes virtually all of the oils from the brew. The result is bright, crisp and citrus-forward — a very different cup from the same beans in a French press.

What you will need for one cup

  • A Chemex brewer
  • A square Chemex filter
  • 25 g of coffee, medium ground
  • 400 ml of water at 93–96°C, plus extra for rinsing
  • A gooseneck pouring kettle
  • A timer, a mug, and ideally a burr grinder and scales
  • A total brew time of 4:00

Method

  1. Place the triple-layered section of the filter on the spout side of the glass.
  2. Rinse the filter with hot water and tip the excess away.
  3. Add the ground coffee and level it with a gentle shake.
  4. Put the Chemex on the scales and reset to zero.
  5. Start the timer and pour 50 ml of water over the grounds until they are saturated. Watch them bloom.
  6. After 30 seconds, pour in another 150 ml.
  7. At 90 seconds, add the remaining 200 ml. All 400 ml should be in by then.
  8. Let it finish dripping. After four minutes, the brew should be ready.

AeroPress

The AeroPress brews a rich, low-bitterness coffee quickly and with very little cleanup. It is the most forgiving method here, and the one we reach for when travelling.

What you will need for one cup

  • 15 g of coffee, medium ground
  • 200 ml of water, plus extra for rinsing
  • An AeroPress and a filter
  • A kettle, a timer and a mug
  • Ideally a burr grinder and scales
  • A total brew time of 2:30

Method

  1. Prepare the ingredients and equipment.
  2. Add the filter paper to the cap and rinse it well.
  3. Heat the water to 97°C.
  4. Place the AeroPress in the inverted position: widened sections top and bottom, screw cap facing up.
  5. Grind the coffee to a medium grind, about the texture of caster sugar.
  6. Add the coffee to the chamber and shake gently to level it.
  7. Put the AeroPress on the scales and reset to zero.
  8. Start the timer and pour 200 g of hot water in a circular motion.
  9. Stir five times, make sure all the grounds are wet, then screw the cap on.
  10. At 1:45, carefully flip the AeroPress onto the mug.
  11. At 2:00, press down firmly. This should take around 30 seconds; keep pressing until you hear a hiss.
  12. Aim to have all the coffee out by 2:30.

Whichever method you use, the coffee matters more than the equipment. Start with coffee roasted recently, grind it just before brewing, and change one variable at a time.